Extron Electronics Extender Series - Manual (Page 14)

Extender Series • Installation
Installation, cont’d
2-4
PRELIMINAR
Y
Connecting Shields.eps
Metal Wall Box
Screw
Braided Shield
Install Cable
Foil Shield
Cable Clamp
Grounding outer braided and foil shields
W To prevent short circuits, the outer foil shield can
be cut back to the point where the cable exits the
cable clamp. Both braided and foil shields should be
connected to an equipment ground at the other end of
the cable.
7 . Insert the wall box into the opening, and attach it to the
wall, stud, or furniture.
•
For the Extender WM, Extender WM AAP,
Extender WM AUS, Extender D, and the Extender AAP
or Extender AAP EX (if installed in a two- or four-gang
AAP plate), attach the wall box to the wall stud or
furniture with nails or screws, leaving the front edge
flush with the outer wall or furniture surface. See the
following illustration, which applies to one-, two-,
three-, and four-gang wall boxes.
1-gang wall box.eps
Installation Cable
Cable Clamp
Wall Stud
Installation Cable
Cable Clamp
Wall Stud
Screws or Nails Screws or Nails
Attaching a wall box to a wall stud