Extron Electronics Extender Series - Manual (Page 12)

Extender Series • Installation
Installation
PRELIMINAR
Y
2-2
C Installation and service must be performed by
authorized personnel only. This product should
be used with a UL approved electrical box. See
“UL Guidelines”, below.
UL Guidelines
1. The Extender must be installed in an Underwriters
Laboratories (UL) listed junction box. The UL approved
electrical wall box (junction box) is not included with the
unit; the installer is responsible for obtaining and installing
the box.
2. The unit must be installed with accordance with the
National Electrical Code and with local electrical codes.
Installation Instructions
Depending on the model, the Extenders can be mounted into
furniture, a wall, an Ackermann floorbox, or an Extron HSA 400
Series or HSA 800 Series enclosure.
For Extender AKM UK AAP mounting instructions, refer to the
AKM UK Series Installation Guide .
For Extender AKM MAAP mounting instructions, refer to the
AKM MAAP Installation Guide .
C The Extender must be installed in a UL listed wall box,
which the installer is responsible for obtaining.
For Extender AAP EX mounting instructions, refer to the user’s
manual or installation manual for the appropriate model of HSA
Hideaway Surface Access enclosure.
N The Extender AAP EX does not require a wall box if
it will be installed into an Extron HSA 400 Series or
HSA 800 Series surface access product. If you install an
Extender AAP EX without an HSA, you must use a wall
box.
Preparing the Site and Installing the Wall Box
Considerations
Choose a location that allows cable runs without interference.
Allow enough depth for both the wall box and the cables.
You may need to install the cables into the wall, furniture, or
conduits before installing the line driver.
• The Extender AAP or Extender AAP EX can be installed
in an Extron two-gang, four-gang, or half rack width AAP
Architectural Adapter Plate or in the faceplate of another
Extron device that accepts AAP plates, such as an interface