Airaid 1021 - Manual (Page 2)

Instructions Revision
11/12/10
6. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Make sure all of the holes are aligned, and then reinstall the
factory bolts and tighten them to the factory specifications.
Before starting the engine, open and close the throttlebody to
make sure there are no obstructions. Reinstall the intake tube,
air cleaner lid, fresh air duct, battery cover, and the beauty
cover in the reverse order that they were removed.
ECONOAID
4. Pull the throttlebody away from the intake manifold. Install
the ECONOAID Throttle Booster (with the logo facing the
throttlebody) and the supplied gasket between the throttlebody
and the intake manifold. The gasket needs to be between the
intake manifold and the ECONOAID. 3. Remove the four bolts that secure the throttlebody to the
intake manifold.
Fiber Gasket
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order num-
ber D-520-4. This decal must be placed in plain
view inside the engine compartment. Failure to do
may prevent you from passing a smog inspection.