Airaid 1020 - Manual (Page 2)

Instructions Revision
11/12/10
6. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the throttlebody onto the intake manifold and
tighten all four bolts to the vehicle manufacturer’s specifica-
tions. Before starting the engine, open and close the throttle-
body to make sure there are no obstructions. Reinstall the
intake tube and the beauty cover in the reverse order that they
were removed.
ECONOAID
4. Install one of the supplied gaskets on each side of the
ECONOAID Throttlebody Booster and then install the
ECONOAID between the intake manifold and the throttle-
body making sure that the logo is facing the throttlebody. 3. Remove the 4 bolts that secure the throttlebody to the in-
take manifold. Remove the throttlebody from the intake mani-
fold and remove the old gasket.
Fiber Gaskets
Included with your ECONOAID Throttlebody Booster
is a decal with the California Air Resources Board
( C.A.R.B. ) Executive Order number D-520-4. This
decal must be placed in plain view inside the engine
compartment. Failure to do may prevent you from
passing a smog inspection.