Airaid 1011 - Manual (Page 2)

Instructions Revision
11/12/10
7. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the throttlebody onto the intake manifold and
tighten all three bolts to the vehicle manufacturer’s specifica-
tions. Before starting the engine, open and close the throttle-
body to make sure there are no obstructions.
ECONOAID
4. Install the supplied gasket between the ECONOAID Throt-
tlebody Booster and the throttlebody making sure that the logo
on the ECONOAID is facing the throttlebody. 3. Remove the 3 bolts that secure the throttlebody to the in-
take manifold.
Fiber Gasket
6. Reinstall the resonator and intake tube in the reverse order
that they were removed. Make sure to reconnect the air tem-
perature sensor.
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order num-
ber D-520-4. This decal must be placed in plain
view inside the engine compartment. Failure to do
may prevent you from passing a smog inspection.