Airaid 1008 - Manual (Page 2)

Instructions Revision
11/12/10
6. Double check your work. Make sure there is no foreign ma-
terial in the intake tract. Make sure all clamps, hoses, nuts, ca-
bles, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the air cleaner and reconnect the crankcase
breather hose, and the plastic fresh air tube.
4. Reinstall the factory bolts thru the throttlebody and tighten
them to the manufacturer’s specifications. Reconnect the vac-
uum hoses and throttle cables. Before starting the engine, open
and close the throttlebody to make sure that there are no ob-
structions. 3. Carefully lift the throttlebody straight up and slide the
ECONOAID Throttlebody Booster with one gasket on each
side and the logo facing up, into position on top of the intake
manifold. Make sure that the bolt holes in the ECONOAID
and the two gaskets are aligned over the bolt holes in the in-
take manifold, and then reinstall the throttlebody.
ECONOAID
Fiber Gaskets
1.
2.
3.
Included with your ECONOAID Throttlebody Booster
is a decal with the California Air Resources Board
( C.A.R.B. ) Executive Order number D-520-4. This
decal must be placed in plain view inside the engine
compartment. Failure to do may prevent you from
passing a smog inspection.