Airaid 883-311 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
13. Mount the duct to the Speed Nuts on the bulkhead
using the two 3” Loop Clamps and 1/4-20 x 1/2’ button
Head Bolts (#8).
10. Install the Flexible Duct onto the Airaid perfor-
mance airbox as shown. Re use the Clamp from step
# 5.
11. Install the other end of the Ducting onto the Snorkel
tube using the #48 Hose Clamp (#16).
12. Full view of Duct routing.
REV.1.28.14
14. Slide the Edge Trim (#17) over the cut out on the
Hood.
15. Align the Snorkel and Ducting and verify the
opening and closing action of the hood is not adversely
effected. Tighten all of the Clamp bolts when done.
16. Double check all of your work and re connect the
battery.
8. Install Slide the Speed Nuts (#11) onto the Cowl
plastic with the threaded side out.
7. Using a jig saw or equivalent, follow the template and
cut out the Duct relief.
9. Using a pair of dykes, pull out approximately three
windings of the steel wire inside of the Ducting (#6)and
cut it off.
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951
8:00 AM - 5:00 PM MST weekdays for questions regarding fit or instructions that are not clear to
you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter
element is protected from direct exposure to water and debris; care should be taken not to drive
through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air fil-
ter is reusable and should be cleaned periodically.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!