Airaid 401-741 - Manual (Page 2)

Installation Instructions. Read Me!
1. Disconnect negative battery
cable. Disconnect valve cover
breather hose from factory
intake tube and valve cover.
2. Loosen hose clamps
connecting the factory intake
tube to the air filter assembly
and throttle body.
3. Remove the factory intake
tube assembly from engine.
4. Airaid Jr. Kit PN#401-741
If you purchased the Airaid Jr.
Kit PN#401-741, replace the
factory air filter with the
Airaid Premium filter included
with the kit.
5. Install the supplied urethane
hump hose and two #80 hose
clamps on factory air filter
assembly. Leave hose clamps
loose until final assembly.
6. Install supplied silicone
reducer on end of throttle
body. Install #48 hose clamp
on small end of the reducer and
#56 hose clamp on the big end
of the reducer. Leave hose
clamps loose until final
assembly.
7. Install the Airaid Modular
Intake Tube on engine.
8. Tighten hose clamps on both
ends of the Modular Intake
Tube.
9. Install the supplied rubber hose
on the Modular Intake Tube.
Connect the other end of the
hose to the valve cover.
Secure both ends of the hose
with the supplied speed
clamps.
10. Double check your work to be
certain that all nuts, bolts, and
clamps are securely fastened.
Reconnect the negative
battery cable.
Before