Airaid 510-734 - Manual (Page 2)

Installation Instructions. Read Me!
I DISCONNECT NEGATIVE (-) BATTERY CABLE
II Remove Factory Intake Assembly
a)
Using Phillips screwdriver, loosen the hose clamps on the factory intake
tube. See Fig#1
b)
Remove vacuum line and hose from the intake tube. Discard original ¼”
vacuum line for longer vacuum line supplied with Airaid MIT. (Note:
Factory hose near throttle body will be reconnected to AirAid intake tube
assembly.) See Fig#1
c)
Disconnect Mass Air Sensor wire harness from intake tube. (Note: Mass
Air Sensor remains in original location.) See Fig#2
d)
Remove factory intake tube assembly from vehicle. (Note: factory air
box assembly remains in original location.) See Fig#2
II Assemble the Airaid Modular Intake Tube
a)
Install supplied nylon barbed fitting in rear threaded hole (furthest from
larger diameter tube end) of Airaid intake tube. See Fig#3
b)
Install supplied ¼” threaded plug into threaded hole (closest to larger
diameter tube end) of Airaid intake tube. See Fig#3
c)
Early models, 1995-98 will use the second barbed fitting. See Fig#4
d)
Place hump hose and two #52 hose clamps on larger end of intake tube
and place coupler with two #48 hose clamps on smaller end of tube. See
Fig#3 (Note: Leave all hose clamps loose for final assembly.)
III Airaid Modular Intake Tube Installation
a)
Position the Airaid intake tube in place of the original factory assembly.
b)
Connect the Airaid intake tube to the engine by sliding the coupler over
the end of the throttle body.
c)
Connect the Airaid intake tube to the factory air box by sliding the hump
hose over the end of the air box.
d)
Adjust the intake tube to insure proper alignment from the throttle body
and the factory air box. (Note: Leave a gap between the tube and the air
box to allow for engine movement.)
e)
Tighten all four hose clamps on the Airaid intake tube.
f)
Using supplied ¼” vacuum line; connect steel tube on intake manifold to
¼” barbed fitting on intake tube.
g)
Using supplied 5/8” to ½” barbed fitting and hose, connect the factory
hose located by the throttle body to the intake tube. Use two supplied #16
speed clamps to secure line to barbed ends. See Fig#5
h)
Re-connect the Mass Air Sensor to the factory tube.
IV Airaid Jr. P/N 300-724 Replacement Filter
a)
If you purchased the Airaid Jr. kit P/N 300-724, replace the factory
air filter with the Airaid Premium Filter included in the Airaid Jr. kit.
V Finishing Up
a)
Tighten all hose clamps & inspect overall work.
b)
Check hood clearance.
c)
Ensure that no foreign objects are in the intake path!
d)
Re-connect negative battery cable.
Rev Date 6/12/12
Fig#1
Fig#2
Fig#3
Fig#4
Fig#5
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com