Airaid 401-740 - Manual (Page 2)

Installation Instructions. Read Me!
I DISCONNECT NEGATIVE (-)
BATTERY CABLE
II Remove Factory Intake Air Tube
a) Remove the mounting bolt behind the factory air
intake tube. See Fig#1
b) Firmly grasp the factory air intake and lift sharply
to unsnap it from the factory air box. See Fig#2
c) Pull the factory air intake tube free from the
fender opening and remove from vehicle. See
Fig#3
III Airaid Modular Intake Tube
Installation
a) Mount the Airaid bracket onto the Airaid tube
using the ¼-20 button head bolt and lock washer
provided. See Fig#4 (Hint: leave the bolt loose
for easy adjustment later in the installation)
b) Position the Airaid tube in place of the factory air
intake assembly. See Fig#5
c) Push the Airaid tube into the factory air box
opening until it snaps into place.
d) Align the Airaid bracket on the Airaid tube to the
factory mounting hole and secure using a #6 bolt
and lock washer provided.
e) Mount the factory radiator overflow hose to the
driver’s side of the engine compartment with the
black plastic hose mount provided. Insert the
mount through the factory hole in the upper fender
and secure by pushing a ¼ washer over the clip.
See Fig#6
f) Tighten the previously installed button head bolt
fastening the bracket to the Airaid tube.
IV Airaid Jr. P/N 401-740 Replacement Filter
a ) If you purchased the Airaid Jr. kit P/N 401-740,
replace the factory air filter with the Airaid
Premium Filter included in the Airaid Jr. kit.
V Re-Connect Accessories
a) Re-connect negative battery cable.
Fig#2
Grasp & Lift Sharply
Fig#3
Fig#4
Fig#5
Push tube into
factory air box
Fig#6
Fig#1