Airaid 310-770 - Manual

Installation Instructions
For Part Numbers:
310-970 Modular Intake Tube
310-770 Jr. Kit
850-233 Airaid Oiled Media Filter
311-770 Jr. Kit 851-233 SynthaMax Dry Media Filter - Red
2005-10 Jeep Grand Cherokee
2006-10 Jeep Commander
5.7L V8 Hemi
Component Identification
1. *Airaid Premium Filter 1
2. Modular Intake Tube 1
3. Coupler 3 ½”x 3” 1
4. Hump Hose 3 ½”x3” 1
5. Grommet 1
6. Nylon zip tie 1
7. #60 Hose Clamp 4
* Filter included only in Jr. Kits
Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.
1. Disconnect the negative battery cable.
Loosen hose clamp on air cleaner box lid.
Carefully twist and remove the breather
hose from the lid.
2. Remove oil fill cap and set aside. 3. Carefully lift the engine cover for access to
the throttle body. (There are only grom-
mets that hold down the cover, no bolts.)
4. A.) Using the 10mm socket, remove the
bolt that holds the stock intake system.
B.) Loosen the hose clamp that holds the
coupler to the throttle body.
5. Carefully pull the intake towards you and
rotate it so the bottom faces you, and cut
the tie wrap that holds the breather tube,
as shown.
6. Slide the clip off of the intake tube that holds
the breather line.
7. Carefully twist and remove the temperature
sensor from the stock intake tube. Remove
the stock intake tube from the vehicle.
8. If you purchased an Airaid Jr. Kit, unhook
the two clips and remove the factory air
filter, and replace it with the Airaid Premi-
um Filter supplied in the kit.
9. Reconnect the breather hose. Install the
hump hose and two #60 hose clamps as
shown. Do not tighten the clamps.