Airaid 300-744 - Manual (Page 2)

Installation Instructions. Read Me!
1. Disconnect the negative battery
cable and remove the breather
hose from the factory air box lid.
2.
Loosen the two hose clamps on
each end of the factory intake
tube.
3.
Unsnap the factory silencer box
from the fan shroud and remove
the factory tube assembly from
the vehicle.
4.
Disconnect the factory electrical
connector from the factory air
temperature sensor.
5. Loosen the two 10mm bolts
mounting the factory air box to
the intake manifold and remove
from vehicle.
6. Turn the air temperature sensor
¼ turn and remove from the air
box. Retain sensor for later use.
7.
Install the reducer hose and a #52
hose clamp onto the throttle
body. Install a #56 hose clamp
onto the other side of the reducer.
8.
Slide the urethane hump hose
onto straight end of Airaid intake
tube with two #60 hose clamps.
(Note: Leave hose clamps loose
until final assembly).
9. Install Airaid intake tube
assembly by connecting the
Airaid hump hose onto the
factory air box lid and the other
end onto the Airaid reducer hose.
Tighten all hose clamps.
Hump Hose