Airaid 300-743 - Manual (Page 2)

Installation Instructions. Read Me!
1. Disconnect negative battery cable.
Remove valve cover breather hose
from air box lid. Loosen hose
clamps on both sides of factory
intake tube.
2. Unsnap factory air box tube baffle
from fan shroud and remove air tube
assembly from vehicle.
3. Carefully disconnect electrical
connector from air temperature
sensor in factory housing.
4. Remove oil fill cap from valve
cover. Using 10mm socket, loosen
two factory housing bolts. Remove
housing from engine.
5. Remove air temperature sensor from
housing by turning counter
clockwise and pull.
6. Remove factory orange seal from
throttle body.
7. Install the supplied grommet and
factory air temperature sensor into
the Airaid MIT.
8. Install the hump hose and coupler
provided onto the Airaid MIT with
the supplied hose clamps. The
straight coupler is positioned on the
throttle body end and the hump hose
is positioned on the air filter end.
9.
Check for any foreign objects or
debris it the intake path
& i nstall
Airaid MIT assembly on engine.
(Note: Leave hose clamps loose until
final assembly)
Hump Hose