Airaid 200-783 - Manual (Page 2)

Figure #6
Installation Instructions. Read Me!
I DISCONNECT NEGATIVE (-)
BATTERY CABLE
II Remove Factory Intake Assembly
a) Remove factory filter minder and rubber
grommet and retain for re-installation.
See Fig#1
b) Loosen the factory hose clamps on each
end of the factory intake tube assembly.
See Fig #2
c) Remove the factory intake tube
assembly from vehicle. See Fig #2
III Airaid Modular Intake Tube
Installation
a) Install the provided coupler with clamp
onto the Airaid Modular Intake Tube
(MIT). See Fig #3
b) Install the urethane hump hose provided
onto the Airaid Modular Intake Tube
(MIT) with the supplied hose clamps.
(Hint: slide the hump hose all the way
onto the end of the MIT. See Fig #4
c) Install the Airaid MIT in place of the
factory intake tube assembly. See Fig
#5
d) Re-install factory filter minder and
rubber grommet into rear of Airaid MIT.
See Fig#6
e) Check for interference and adjust the
MIT accordingly, then tighten the hose
clamps.
IV Airaid Jr. P/N 200-783 Replacement
Filter
a) If you purchased the Airaid Jr. kit P/N
200-783, replace the factory air filter with
the Airaid Premium Filter included in the
Airaid Jr. kit.
V Finishing Up
a) Make sure that the intake path is clear of
debris.
b) Double check work to ensure proper fit
and that all clamps are securely fastened.
c) Re-connect negative battery cable.
Figure #2
Figure #5
Figure #4 Figure #3
See Local Dealer For Details.
P/N 200-183
Figure #1
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
www.airaid.com
Rev.08.22.13