Airaid 520-505 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (4) bolts from the throttle body. (Ref. “C”)
4. Remove gasket and clean surfaces.
5. Remove bolts from the throttle linkage bracket and save.
6. Install power plate with (2) gaskets. (Ref. “A” & “B”)
A. Install one gasket between the throttle body and power plate.
B. Install second gasket between the power plate and manifold.
7. Replace (4) bolts and washers (Ref. “C”) using Step 3 as an example.
8. Install throttle linkage plate using (2) 6mm flat head screws. (Ref. “D”)
9. Reinstall the throttle linkage bracket using saved bolts. Refer to Step 5.
10. Inspect & Test the throttle linkage for full open & closed travel before driving. Some cruise or kickdown
cables may require adjustment. Please refer to your vehicles service manual for proper adjusting.
11. Reinstall the throttle body air intake assembly using Step 2 as an example.
12. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 07/12/06
Ref. “A”- (1) Power Plate
(2) Gaskets
Ref. “B”- Throttle Body
Ref. “C”- (4) 8mm x 50mm Bolts
(4) 8mm Flat Washers
Ref. “D”- (1) Linkage Plate
(2) 6mm x 12mm Flat Head Screws
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com