Airaid 510-621 User Manual
Page 2
Instructions Revision
10.09.13
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
3. Using pliers, squeeze the tabs on the coolant
hose clamp together. Slide the hose and clamp
towards the passenger side approximately one half
inch.
4. Using a 10mm socket, remove the four factory
bolts on the throttle body. Gently move the throttle
body towards the passenger side of the vehicle.
Slide the Poweraid Spacer (#1) and gasket (#2)
between the throttle body and intake manifold.
Insert four 6mm x 65mm hex bolts (#3), and 6mm
flat washers (#4) thru the throttle body, gasket,
Poweraid Spacer, and into the intake manifold.
Using a 10mm socket, tighten all four throttle body
bolts evenly, to the manufacturers specifications.
Do Not Over Tighten The Bolts!
Gasket
Poweraid
Spacer
5. Re-install the factory intake tube and tighten the
hose clamps securely.
6. Re-install the engine beauty cover.
Reconnect the negative battery cable!
6mm Hex
Bolts
6mm Flat
Washers