Airaid 510-502 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove throttle linkage bracket and save 10mm bolt. (Ref. “D”)
4. Remove vacuum line clip, and also linkage bracket used on some models. Save the 8mm bolt for models having
a linkage bracket. (Ref. “E”)
5. Remove nuts and studs from the throttle body. (Ref. “C”)
6. Install the power plate using (2) gaskets, (4) 8mm bolts, and (4) 8mm lock washers. (Ref. “A”, “B”, “C”)
A. Install one gasket between the throttle body and power plate.
B. Install second gasket between the power plate and manifold.
7. Install throttle linkage plate using a 10mm x 20mm bolt and reinstall the throttle linkage bracket using saved
10mm bolt. (Ref. “D”)
8. Install extension plate using 8mm flat head screw and reinstall linkage bracket used on some models with saved
8mm bolt. Attach vacuum line clip to bottom side of extension plate using furnished 8mm bolt. (Ref. “E”)
9. Inspect & Test throttle linkage for full open & closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
10. Reinstall air intake system using Step 2 as an example.
11. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 12/01/06
Ref. “A”- Throttle Body
Ref. “B”- (1) Power Plate
(2) Gaskets
Ref. “C”- (4) 8mm x 90mm Bolts
(4) 8mm Lock Washers
Ref. “D”- (1) Linkage Bracket
(1) 10mm x 20mm Bolt
Ref. “E”- (1) Extension Plate
(1) 8mm x 16mm Flat Head Screw
(1) 8mm x 10mm Bolt
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com