Airaid 450-638 User Manual
Airaid Accessories for air

Parts List
#1 Poweraid Spacer
x1
#2 6mmx70mm Bolt
x4
#3 6mm Flat Washer
x4
#4 Gasket
x1
8mm, 10mm Socket
Ratchet and Extension
Installation Instructions
Part Number 450-638
2011 –15 Ford Mustang
2011 –15 Ford F-150
5.0L V8
1. Disconnect the negative battery cable!
A.) Disconnect the breather line or lines, from the factory intake
tube.
B.) loosen the clamps securing the intake tube to the throttle-
body and the airbox.
C.) Remove the Factory intake tube and set aside.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceed-
ing with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instruc-
tions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
2. Remove the four bolts that secure the throttlebody to the
intake manifold and set them aside. They will not be reused.
NOTE: These instructions depict an
installation being performed on a 5.0l F-
150 and is meant to be a guide for all
other makes and models listed. While
some details may vary from vehicle to
vehicle, the general install procedure
remains the same.
A
C
B
B