Airaid 400-619 - Manual (Page 2)

Instructions Revision
07/19/12
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
3. Remove the factory black plastic spacer that is
located between the throttle body and the intake
manifold. 4. Insert four 6mm hex bolts thru the 6mm flat wash-
ers (#5). Use the 6mm x 55mm hex bolts (#3) on the
Explorer, and use the 6mm x 75mm hex bolts (#4)
on the F-150. Slide the four bolts with washers thru the
throttlebody, one gasket, the Poweraid Spacer, the other
gasket, and into the intake manifold.. Make sure to rein-
stall the wiring harness anchor removed in step #2, on
the Explorer. Tighten all four throttle body bolts
evenly, to the manufacturer’s specifications. Do
Not Over Tighten The Bolts!
Gasket
Gasket
Spacer
5. Re-install the factory intake tube onto the throttle
body and tighten the hose clamp. Re-connect the
breather hose to the factory intake tube.
Re-connect the negative battery cable!
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.