Airaid 400-601 - Manual (Page 2)

2
Instructions Revision
07/12/06
Contact your nearest AIRAID dealer for an AIRAID Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
1. Disconnect the negative battery cable!
2. Loosen clamp at intake manifold leaving clamp on plastic tube.
3. Slide the plastic tube back and insert power plate into tube.
4. Reinstall the plastic tube making sure the power plate is engaged in manifold while locating and
tightening the hose clamp.
5. When installing the power plate in the intake manifold, face the power plate using the illustration
below.
6. Before tightening the intake manifold clamp, be sure that the power plate has engaged both the
intake manifold and plastic intake tube. **The outside diameters of the power plate will fit the
inside diameters of the intake manifold and the plastic intake tube.
7. Reconnect negative battery cable. Enjoy!
INTAKE MANIFOLD POWER PLATE HOSE CLAMP ASSEMBLY
FORMED INTAKE TUBE
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.