Airaid 400-595 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen (2) hose clamps and remove rubber hose. (Ref. “C”)
3. Remove compression ring. (Ref. “B”)
4. Install power plate with a small amount of grease on the installing edge of the power plate for ease of installa-
tion. (Ref. “A”)
5. Locate the power plate midway of rubber hose making sure the power plate locks into the internal buldge of
the formed rubber hose.
6. When installing the power plate hose assembly to intake manifold, face the power plate using Figure 1.
7. Before tightening clamps, be sure that power plate has engaged both the intake manifold and formed intake
tube. * Please Note: The outside diameters of the power plate will fit inside the diameters of the intake
manifold and the formed intake tube.
The sound of power...The “whistle” means its working!
Rv. 06/06
Figure 1
Ref. A– Power Plate Ref. D– Formed Intake Tube
Ref. B– Compression Ring Ref. C- Hose Clamp Assembly
Figure 1
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com