Airaid 400-594 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner housing from the throttle body.
3. Remove (2) bolts and (2) studs from throttle body. (Ref. “D”)
4. Remove (2) bolts from throttle linkage bracket.
5. Remove throttle body from intake manifold; remove gasket and clean surfaces.
6. Install power plate using (2) gaskets. (Ref. “A”)
A. Place one gasket between the throttle body and power plate.
B. Place second gasket between the power plate and intake manifold.
7. Locate (1) linkage plate using (2) flat head screws (Ref. “C”); relocate the throttle linkage bracket using (2)
6mm bolts.
8. Inspect & Test the throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown
cables may require adjustment. Please refer to your vehicles service manual for proper adjusting.
9. Reinstall the air cleaner housing. Refer to Step 2
10. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 11/09/06
Ref. “D”- (4) 6mm x 60mm Bolts
(4) 6mm Lock Washers
Ref. “C”- (2) 6mm Flat Head Screws
(1) Linkage Bracket
Ref. “A”- (1) Power Plate
(2) Gaskets
Ref. “B”- Throttle Body
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com