Airaid 400-519 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner housing from the throttle body.
3. Remove (3) bolts and (1) stud from the front side of the throttle body. (Ref. “D”)
4. Remove (2) bolts from the throttle linkage bracket.
5. Move throttle body away from intake manifold. Remove old gasket and clean surfaces.
6. Install power plate using (2) gaskets. (Ref. “A” & “B”)
A. Place one gasket between the throttle body and power plate.
B. Place second gasket between the power plate and manifold.
7. Install (4) 8mm x 50mm bolts, (4) 8mm washers and tighten evenly. (Ref. “D”)
8. Locate (2) linkage plates using (2) flat head screws. (Ref. “C”)
9. Relocate throttle linkage bracket using (2) 5/16-18” bolts.
10. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kick down cables
may require adjustment. Please refer to your vehicles service manual for proper adjustment.
11. Reinstall air cleaner housing (Refer to Step 1)
12. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 12/01/06
Ref. “A”- (1) Power Plate
(2) Gaskets
Ref. “B”- Throttle Body
Ref. “C”- (2) 5/16-18” Linkage Plates
(2) 8mm Flat Head Screws
(2) 5/16-18” x 5/8” Bolts
(2) 5/16” Flat Washers
Ref. “D”- (4) 8mm x 50mm Bolts
(4) 8mm Washers
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com