Airaid 400-507 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake cover.
3. Remove air intake hose assembly.
4. Remove (4) bolts from the throttle body.
5. Remove throttle linkage bracket and save screws. (Ref. “B” & “C”)
6. Install power plate with (2) “O”rings in place using (4) lag screws & (4) 1/4” washers. (Ref. “A”)
7. Install throttle linkage bracket using linkage plate extenders as shown (Ref. “B” & “C”) using 6mm x 12mm
flat head screws and saved screws in (Step #5).
8. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
9. Reinstall air intake hose assembly (Step #2).
10. Install throttle body intake cover. * Please Note: Make a cutout for the cruise control cable. (Ref. “D”)
11. Reconnect negative battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 09-07-10
Ref. “D”- Clearance cutout for Cruise Control
Ref. “C”- (1) Extension Plate
(1) 6mm x 12mm Flat Head Screw
Ref. “B”- (1) Extension Plate
(1) 6mm x 12mm Flat Head Screw
Ref. “A”- (1) Power Plate
(2) “O”-rings
(4) 1/4” x 2 1/2” lag screws
(4) 1/4” Flat Washers
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com