Airaid 310-616 User Manual
Page 2
Instructions Revision
03/16/11
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
3. Install the Poweraid Spacer and the fiber gasket
between the intake manifold, and the throttle body,
as shown. Tighten all 4 throttle body bolts evenly,
to the manufacturer’s specifications.
Do Not Over Tighten The Bolts!
4. Reinstall the factory intake tube, and tighten the 2
hose clamps. Reconnect the wiring harness to the
intake tube temperature sensor. Make sure you push
down the red tab, and lock the harness.
Re-connect the negative battery cable!
Spacer
Gasket
Throttle Body
See also other documents in the category Airaid Accessories for air:
- 883-283 (7 pages)
- 200-585-1 (2 pages)
- 200-583 (2 pages)
- 300-561 (2 pages)
- 400-531 (2 pages)
- 200-512-1 (2 pages)
- 200-555 (2 pages)
- 200-543 (2 pages)
- 200-557 (2 pages)
- 200-580 (2 pages)
- 200-584 (2 pages)
- 200-586 (2 pages)
- 200-589 (2 pages)
- 200-617 (2 pages)
- 200-612-P (2 pages)
- 200-615 (2 pages)
- 200-630-1 (2 pages)
- 250-634 (2 pages)
- 300-560 (2 pages)
- 300-562 (2 pages)
- 300-564-P (2 pages)
- 300-563 (2 pages)
- 300-565 (2 pages)
- 300-567 (2 pages)
- 300-568 (2 pages)
- 300-570 (2 pages)
- 300-573 (2 pages)
- 300-574 (2 pages)
- 300-575 (2 pages)
- 300-577 (2 pages)
- 300-626 (2 pages)
- 300-631-1 (2 pages)
- 310-506 (2 pages)
- 300-637 (2 pages)
- 310-508 (2 pages)
- 310-509 (2 pages)
- 310-510 (2 pages)
- 310-515 (2 pages)
- 310-511 (2 pages)
- 310-618 (2 pages)
- 350-532 (2 pages)
- 350-635 (2 pages)
- 400-516 (2 pages)
- 400-507 (2 pages)