Airaid 300-631-1 - Manual (Page 2)

Instructions Revision
01.13.15
The sound of power...The “whistle” means its working!
6. Reinstall the engine cover and intake tube in the reverse order
that they were removed. Make sure to reconnect the temperature
sensor.
Re-connect the negative battery cable!
4. Install the supplied o-ring into the groove on the Poweraid
Spacer. Next install the spacer onto the intake manifold with the
o-ring facing up, making sure that the alignment pin holes are
located over the alignment pins. 5. Reinstall the throttlebody on top of the Poweraid Spacer us-
ing the four bolts and the washers that were selected in step 3.
Tighten the bolts evenly, in an X pattern, to the vehicle manu-
facturers specifications.
Alignment Pin
O-ring
3. Measure your OEM hardware to determine which Poweraid bolts you will need. Measure the shank only. Use
the chart below to select the proper bolts.
Late models 2012.5-2013
OEM Green bolt 45mm (1 3/4”) use 63mm (2 1/2”) bolt , Pack A
Early models 2009-2012.5
OEM Silver bolt 55mm (2 1/8”) , use 70mm (2 3/4”) bolt, Pack B
Verify the length of all four Poweraid bolts before proceeding. Proper identification of the Throttle Body hardware is imper-
ative
to prevent severe intake manifold damage.
MEASURE BOLT SHANK