Airaid 300-575 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove the throttle body intake cover and save bolts.
3. Remove air intake assembly.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60mm bolts and flat washers. (Ref. “D”)
7. Locate (3) linkage plates and (3) 6mm x 20mm flat head screws before installing the throttle linkage and dip-
stick bracket. * Please Note: Remove the stud from front throttle linkage mount. Dipstick must be relo-
cated to forward mount on lower linkage plate using 6mm x 12mm bolt and lock washer.
8. Locate (2) linkage plates using (2) flat head screws to reposition throttle body cover using saved bolts. Refer
to Step 1.
9. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
10. Reinstall the throttle body air intake assembly using Step 3 as an example.
11. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rv. 04/04
Ref. “A”- (1) Power Plate
(1) “O”-ring
Ref. “D”- (3) 6mm x 60mm Bolts
(3) 6mm Flat Washers
Ref. “B”- Throttle Body
Ref. “C”- (5) 3/4” Linkage Plates
(5) 6mm x 20mm Flat Head Screws
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com