Airaid 300-568 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake cover and save bolts.
3. Remove air intake assembly.
4. Remove throttle cables & throttle linkage bracket from throttle body.
5. Remove 8mm bolt and washer from throttle body support bracket. (Ref. “B”)
6. Remove (3) 6mm bolts from throttle body.
7. Remount throttle body temporarily to outboard side of bracket using original 8mm bolt and washer. Install 8mm
bolt and washer from opposite side of support bracket to be tightened after throttle body and power plate have been
installed.
8. Locate and install power plate and throttle body using (3) 6mm x 55mm bolts and washers. (Ref. “A”)
9. Tighten 8mm support bracket bolt by using a 1/4” x 12” extension and 13mm socket.
* Note– The 8mm support bracket bolt can accessed under the intake manifold to be tightened. (Ref. “B”)
10. Connect throttle bracket cables and reinstall throttle bracket. (Ref. to Step 4)
11. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables may
require adjustment. Please refer to your vehicles service manual for proper adjustment.
12. Reinstall throttle body air intake assembly and cover using Step 3 as an example.
13. Reconnect negative battery cable. Enjoy!
*Note -Due to wide manufacturing tolerances, the computer may need to be shifted away from the
throttle body, toward the driver’s side of the vehicle. Loosening the three computer mounting
screws and biasing away from the throttle body may be enough. (Ref. “C”)
The sound of power...The “whistle” means its working!
Ref. “A”- (1) Power Plate
(1) “O” Ring
(3) 6mm x 55mm Bolts
Ref. “C”
Ref. “B”- Support Bracket
(8mm Bolt & Washer)
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Rev. 09/25/08