Airaid 300-562 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system
3. Remove throttle linkage bracket and save bolts.
4. Remove (4) throttle body studs.
5. Install first power plate using (2) gaskets, 8mm bolts, and 8mm washers. (Ref. “A”)
6. Install (2) linkage plates using (2) 6mm flat head screws. (Ref. “D”)
7. Repeat previous steps for installation of spacer on second throttle body.
8. Install linkage bracket using saved 6mm bolts.
9. Inspect & Test the throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown
cables require adjustment. Please refer to your vehicles service manual for proper adjusting.
10. Reinstall air intake system. Refer to Step 2
11. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rv. 04/04
Ref. “A”- (2) Power Plates
(4) Gaskets
Ref. “B”- (2) Throttle Bodies
Ref. “C”- (2) Linkage Plates
(2) 6mm x 12mm Flat Head Screws
Ref. “D”- (4) 8mm x 70mm Bolts
(4) 8mm Lock Washers
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com