Airaid 200-612-P - Manual (Page 2)

5. Install the three linkage plates (#5) with the
three flat head screws (#6) as shown, pointing
towards the front of the vehicle.
6. Make sure the direction of the airflow is cor-
rect on the Poweraid Spacer (#1), then with the
gasket (#4) on the throttle body side, slide the
Poweraid between the throttle body and the
intake manifold. Install the top bolt (#2) and
washer (#3) first, then the two bottom bolts and
washers.
Instructions Revision
11/08/06
Contact your nearest Airaid dealer for an Airaid Intake System for your car, truck or SUV.
3. Using a 4mm socket, remove the three studs
that hold the throttle body to the intake mani-
fold. No need to remove the throttle body, leave
it hang where it is. 4. Using a 5/16” socket, remove and save the
three bolts that hold the throttle cable bracket to
the intake manifold.
7. Re-install the bolts from step #4 into the
three linkage plates. Some adjusting of the link-
age plates may be required.
9. Re-install the intake tube and beauty cover. Refer to step
#1.
10.. Re-connect the negative battery cable!
Please refer to a nitrous oxide manufacturer for proper
application for your vehicle. Be sure to follow the manu-
facture’s instructions and warnings when using nitrous
oxide.
8. Inspect & test the throttle linkage for full open and
closed travel before driving. Some cruise and kickdown
cables may require adjustment. Please refer to vehicles
service manual for proper adjustment.
The Sound of Power…. The “Whistle” means
it’s working!