Airaid 200-586 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (4) nuts & studs from the throttle body and manifold. (Ref. “C”)
4. Install power plate using (4) 6mm x 60mm bolts and (4) 6mm flat washers. (Ref. “C”)
* Please Note: The engraved side of plate faces the throttle body
5. Install (2) extension plates using (2) 6mm flat head screws. (Ref. “D”)
6. Inspect & Test throttle linkage for full open & closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjustment.
7. Reinstall the air intake system using Step 2 as an example.
8. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rev. 02/04/09
Ref. “A”- (1) Power Plate
(1) “O”-ring
Ref. “B”- Throttle Body
Ref. “C”- (4) 6mm x 60mm Bolts
(4) 6mm Flat Washers
Ref. “D”- (2) Extension Plates
(2) 6mm x 25mm Flat Head Screws
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com