Airaid 200-543 - Manual (Page 2)

Instructions Revision
01.26.15
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
5 . Reinstall the intake system and tighten the two hose clamps.
Reconnect the valve cover breather lines.
Re-connect the negative battery cable!
3. Install the Poweraid Spacer into the intake manifold with the
supplied gasket on the throttlebody side, as shown. Make sure
the “flow” arrow that is printed on the spacer is pointing to-
wards the intake manifold.
4. Insert the provided bolts with washers through the throttle-
body, gasket, and Poweraid Spacer and tighten them in an “X”
Pattern.
2. Remove the four bolts that secure the throttlebody to the
intake manifold and set them aside. They will not be reused.
1
2
3
4