Airaid 200-555 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove (3) nuts and studs from the throttle body.
4. Install power plate using (3) 6mm x 55m bolts and (3) 6mm flat washers. (Ref. “B”)
* Please Note: Place gasket between throttle body and the power plate.
5. Install extension plate using (1) 6mm x 16mm flat head screw. (Ref. “C”)
6. Reinstall throttle body air intake assembly using Step 2 as an example.
7. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Ref. A- (1) Power Plate
(1) Gasket
Ref. B- (3) 6mm x 55mm Bolts
(3) 6mm Flat Washers
Ref. C- (1) Extension Plate
(1) 6mm x 16mm Flat Head Screw
Instructions Revision
07/11/06
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.