Installation instructions. read me – Airaid 200-550 User Manual
Page 2
2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner.
3. Using 1/2” socket, remove (3) 5/16” bolts.
* Please Note: Some units have bolts that are drilled and tapped for air cleaner mounting studs.
4. It is not necessary to remove the fuel lines.
5. Remove fuel line bracket from transmission. (Located on drivers side of bell housing)
6. Lift throttle body unit.
7. Remove gasket and clean surfaces.
8. Install power plate using (2) gaskets.
A. Locate first gasket between TBI unit and power plate.
B. Locate second gasket between power plate and manifold.
9. Install power plate using (2) drilled and tapped bolts, (1) hex bolt, and three 8mm flat washers. Refer to Step 3
10. Replace air cleaner studs if applicable.
11. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjusting.
12. Reinstall the air cleaner.
13. Reinstall fuel line bracket. Refer to Step 5
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com
14. Reconnect battery cable. Enjoy!
The sound of power...the “whistle” means it’s working!
Rev. 12/27/06