Eiki LC-XB42 - Manual (Page 61)

61
Appendix
The image is distorted or runs off . – Check "PC adjustment" menu or "Screen" menu and adjust them.
(see pages 29,30, 34,35)
PIN code dialog box appears – PIN code lock is being set. Enter a PIN code (the “1234” or numbers
at start-up . you have set).( See pages 19, 50,51)
The Remote Control does – Check the batteries.
not work . – Make sure no obstruction is between the projector and remote
control.
– Make sure you are not too far from the projector when using the
remote control. Maximum operating range is 16.4'(5 m).
– Make sure the code of the remote control is conformed to the
projector’s code. (See page 49)
– Unlock the Key lock function for the remote control function. (See
page 50)
Indicator blinks or lights . – Check the status of the projector with referring to "Indicators and
projector Condition".(see page 65 )
The exclamation mark appears – Your operation is invalid. Operate correctly.
on the screen .
Top control does not work . – The top control is not available if the top control is locked at "Key
lock" under "Security" of SETTING section. Please check "SETTING"
section on page 50.
Unable to unlock the Logo PIN – Contact the dealer where you purchased the projector or the service
code lock, Security key lock center.
or Security PIN code lock .