Eiki LC-XB42 - Manual (Page 59)

59
Problem: – Solutions
No power – Plug the power cord of the projector into the AC outlet.
– See if the POWER indicator lights red.
– Wait until the POWER indicator stops blinking to turn on the projector
again. The projector can be turned on after the POWER indicator
turns red. (See page 19)
– Check the WARNING indicator. If the WARNING indicator lights red,
projector cannot be turned on. (See page 54)
– Check the projection lamp. (See page 57)
– Unlock the Key lock function for the projector. (See page 50)
The initial display is not shown . – Make sure "Off" or "Countdown off" are not chosen at display
function.(see page 44)
The initial display is not same – Make sure "User" or "Off" are not chosen at Logo (select)
as the default set . function.(see page 45)
Input signal switches automatically . – Make sure Input search function is adjusted properly. (See page 47)
(or does not switch automatically)
when the projector is on and you – That is the Filter warning icon. (See page 53)
press the input button, an icon
other than the Lamp mode icon
appears.
An icon other than Input mode or – That is the Lamp replacement icon or the Filter warning icon.
Lamp mode icon appears . (See pages 52,53)
Image is out of focus . – Adjust focus of the projector. (See page 23)
– Provide proper distance between the projector and the projection
screen. (See page 14)
– Check the projection lens to see if it needs cleaning. (See page 56)
– Moving the projector from a cool to warm place may result in
moisture condensation on the projection lens. In such cases, leave
the projector off and wait until condensation evaporates.
Image is Left/Right reversed . – Check the Ceiling/Rear function. (See page 47)
Image is Top/Bottom reversed . – Check the Top/Bottom function. (See page 47)
Picture is not bright enough .
– Check if the 'Contrast" or "Brightness" are adjusted properly.(see
pages 33,40)
– Check if "Image mode" is selected properly.(see pages 32,39)
– Check the lamp control function.(see page 25)
– Check the LAMP REPLACE indicator. If it lights, the end of lamp life
is approaching. Replace the lamp with a new one promptly.(see page
57)
Appendix
Troubleshooting
Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on pages 16-18.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When the projector does not project an image from the connected computer, restart the computer.