Eiki LC-XB42 - Manual (Page 47)

47
Setting
Ceiling
Rear
Ceiling
When this function is set to “On,” the picture will be top/
bottom and left/right reversed. This function is used to
project the image from a ceiling-mounted projector.
Rear
When this function is set to “On,” the picture will be left/right
reversed. This function is used to project the image from
rear of the screen.
Input search
This function detects the input signal automatically. When
a signal is found, the search will stop. Use the Point
◄►
buttons to select one of the following options.
Off .......... Input search will not work.
On1 ........ Input search works under the following situation.
– When pressing the INPUT button on the top
control.
– When pressing the COMPUTER button or
VIDEO button on the remote control.
On2 ........ Input search works under the following situation.
– When turning on the projector by pressing the
POWER ON/STAND-BY button on the top
control or the remote control.
– When pressing the COMPUTER button or
VIDEO button on the remote control.
– When pressing the INPUT button on the top
control.
– When the current input signal is cut off.*
*If the No show or Freeze function is active, cancel it to
activate the Input search. It is also unavailable when On-
Screen menu is displayed.

Notes:
• While Input search is set to “On1” or “On2,” the status of Input and Lamp are displayed every time the signal
is switched.
• If the INPUT button on the top control or COMPUTER or VIDEO buttons on the remote control is pressed
during Input search is in progress, Input search will stop.