Eiki LC-XB42 - Manual (Page 37)

37
Video Input
Choose Computer 2 by pressing the INPUT button on the
top control or press the COMPUTER button on the remote
control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
Use the Point ▲▼ buttons to move the red arrow
pointer to Computer 2 and then press the SELECT
button.
2
After the Source Select Menu appeared for Computer
2, move the pointer to Component or RGB(Scart) and
then press the SELECT button. 3
Input Source Selection (Component, RGB Scart 21-pin)
When the input source is coming from video
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 2/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
RGB (Scart)
Computer 1
Video
INPUT button
Computer 2
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point
◄► buttons to move the red frame
pointer to the Input Menu icon.
Top Control

Note:
• When the Input Search function is set to “On1” or “On2”,
the input signal will be searched automatically (p.47).
Computer 1
Computer 2
REMOTE CONTROL
COMPUTER button
Computer
2
Input Menu
Move the pointer (red arrow)
to Computer 2 and press the
SELECT button.
Input Menu icon
Move the pointer to Component
or RGB(Scart)and press the
SELECT button.
Source Select Menu