Enterasys Networks Enterasys Matrix 6H352-25 - Manual (Page 28)

Unpacking the 6H352-25
3-2 Installation
3.1 UNPACKING THE 6H352-25
Unpack the module as follows:
1. Open the box and remove the packing material protecting the 6H352-25.
2. Verify the contents of the carton as listed in Table 3-1 .
3. Remove the tape seal on the non-conductive bag to remove the 6H352-25.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to Getting Help for details.
3.2 INSTALLING OPTIONAL HSIM, VHSIM, OR FLASH MEMORY
UPGRADE
If the 6H352-25 is to be installed with an optional HSIM or VHSIM, refer to the user’s guide of the
HSIM or VHSIM for complete installation instructions, or
Appendix B for the placement of the
HSIM or VHSIM on the 6H352-25.
For a FLASH memory upgrade, refer to Appendix B for installation instructions.
Table 3-1 Contents of Module Carton
Item Quantity
The 6H352-25 Module 1
Antistatic Wrist Strap 1
Manual Accessory Kit 1
NOTE: Install any optional equipment before proceeding to Section 3.3 .