Welltech ePBX40 V.2.0 - Manual (Page 78)

Welltech Technology Co., Ltd. 78
routed to the secondary default gateway for proper operation.
The default is
Disable .
Secondary Default
Gateway Enter the Secondary Default Gateway. If you choose the
Default Gateway Backup to Enable.
Check Point Enter the Check Point IP address. ePBX40 Ping this IP address
to verify if there are any connection problem happened on
primary default gateway connections.
If you choose the Default
Gateway Backup to Enable.
Current use Default
Gateway This field will display current used Default Gateway IP address.
PPPoE ID Enter the PPPoE ID if you choose the Mode to PPPoE.
PPPoE PWD Enter the PPPoE Password if you choose the Mode to PPPoE.
MAC This field shows up the MAC address. T he MAC address can not
be modified.
LAN
IP Address Enter the LAN port IP Address. The default is 192.168.123.123 .
Subnet Mask Enter the Subnet Mask Address. The default is 255.255.255.0.
MAC This field shows up the MAC address. The MAC address cannot
be modified.
Network Routing Table
Select Select this check box to modify or delete it.
Destination This field shows up the IP address.
Network This field shows up the Subnet Mask address.
Gateway This field shows up the Default Gateway address.
Add Click the Add button to display a new Network Route screen.
Modify IP address can be modified by clicking the checkbox next to the
IP address and click the Modify button.
Delete IP address can be deleted by clicking the checkbox next to the
IP address and click the Delete button.
Apply Click the Apply button to save your customized settings and
exit this screen.
Cancel Click the Cancel button to exit this screen without saving.
Click Add or Modify. The screen appears as follows.
You can add or modify a network routing record. Input subnet as Destination, subnet mask
as Net mask, and gateway as Gateway.