Welltech ePBX40 V.2.0 - Manual (Page 11)

Welltech Technology Co., Ltd. 11
TEL1~TEL4 The status LED for FXO port 1-4, this will light up amber orange when the
connected phone is engaged in a conversation. It will flash amber orange when
there is an incoming call.
Table 1.2.1 front panel
LED and COM
port
Description
Power
When the power adapter is connected, the LED light up green.
WAN
This LED light up green when the gateway’s WAN port is physically
connected to the public internet. It will flash green. The default IP of
WAN port is DHCP.
WAN status
When data is transmitted through this port, it flashes green.
LAN
This LED light up green when the gateway’s LAN port is physically
connected to a local network (Refer to Rear Panel section for location of
LAN port). The default IP of LAN port is 192.168.123.123 .
LAN status
When data is transmitted through this port, it will flash green.
Line1 to Line4
The LED status of FXO ports 1-4 are as follows.
1. Flashing: No PSTN/PBX line connects to RJ-11 FXO port.
2. Steady OFF: PSTN/PBX line connects to RJ-11 FXO port and in Idle
mode.
3. Flashing: An incoming Ring to FXO port.
4. Steady ON: FXO port is in busy status.
1.2.2 The Back Panel
Here are back Panel photo.
Figure 1.2.2 Back Panel
Table 1.2.2 back panel
Item Description
Line 1 to Line 4 The RJ-11 socket for PSTN/FXO line ( the color is gray )
LAN
10/100 Base-T RJ-45 socket for LAN port, connects to computer for
Webpage configuration.
And also let SIP IP devises connect at private IP
address. It doesn’t support data Internet connection.
WAN
10/100 Base-T RJ-45 socket for WAN port, connects to the Internet IP
network.
The IP address of WAN port is used for other extensions to
register at ePBX40 IP-PBX.
DC12V-1.5A The power socket, input with DC 12V at 1.5A rating.