Welltech ePBX40 V.2.0 - Manual (Page 30)

Welltech Technology Co., Ltd. 30
3.1.2 Tone Setting
The configuration page is used to set up the disconnect tone to be detected. The detected tone is
the Disconnect Tone 1 & 2 (for FXO Line) and the others tone are used for FXS gateway generating
purpose. The disconnect tone was generated from PSTN Line to inform FXO Line that the remote
party drop this call.
Figure 3.1.2-1 Tone Setting
Table 3.1.2-1 Tone Setting
Label Description
Disconnect Tone
Recording Click button of “Go” to go to the Disconnect Tone Recording
page.
See 3.1.3 Disconnect Tone Recording
Country Template To select a Country to use the tone parameters. When you
select a country, the following tone was configured
automatically according to that country’s tone specification.
Copy After you have selected country and press “COPY” command,
the corresponded tone of that country will be configured
automatically.
Signal Type Define desire Tone type such as continuous or Cadence tone.
Freq 1
(0,300-1980Hz) In most case, the tone was generated by dual tone frequency.
This field was to fill in the low frequency if you have dual
frequency or single frequency.
Freq 2
(0,300-1980Hz) The high frequency was filled in here if there is dual frequency
tone.
Level 1 (0-63db) The tone strength level of low frequency. Default is 13 dB.
Level 2 (0-63db) The tone strength level of high frequency. Default is 13 dB.
On 1 (0-10230ms) To configure ON time of the first cycle cadence Tone.
Off 1 (0-10230ms) To configure OFF time of the first cycle cadence Tone.
On 2 (0-10230ms) Some tone may provide the second cycle of tone cadence. This
field support ON time of the second cadence tone.
If your