Welltech ePBX40 V.2.0 - Manual (Page 23)

Welltech Technology Co., Ltd. 23
[ext+allroutes] . You can define an “Outgoing call” record to a
certain route level, such as R1, R2…, etc.
1.[from-pstn] is used for Trunk only . An incoming call from
External FXO gateway or IP Trunk, it can only reach assigned
operator, extensions, group or matched schedule call rule.
2.[ext-only] means this External subscribers can reach not only
defined above “from–pstn” features and all Extensions, but
also activate applications such as DND, Call Forward, Extension
Password, CLID and etc. It can also uses PBX features such as
Pick up, Call Park, Speed dial and etc.
3.[ext+R1] means the external subscribers with such Dial Plan
can call to Extensions and Route Level with R1.
4.[ext+R12] means the external subscribers with such Dial
Plan can call to Extensions and Route Level with R1 and R2.
5.[ext+R123] means the external subscribers with such Dial
Plan can call to Extensions and Route Level with R1, R2 and R3.
6.[ext+allroutes] means the external subscribers with such
Dial Plan can call to Extension and Route Level with R1, R2, R3
and R4 (allroutes).
Note: For more information about Route Level, please refer to
Chapter 3.2.7 : Outgoing Routing.
Keypad (DTMF Tone
Type) External FXO gateway and IP Trunk can select Keypad type to
be
RFC2833, In-band, or SIP-Info and Auto. To choose
Auto to select Keypad type automatically. Choose RFC2833,
In-band or SIP-Info will force the Extension to use RFC2833,
In-band or SIP-Info accordingly and the setting should be
matched the Keypad setting of Trunk device.
NAT Traversal If the SIP IP device is located at different location (via remote
Internet) with ePBX40 and install behind an NAT device, such
as firewall or router, and want to register at ePBX40 via IP
network. Then this function has to be enabled. Enable
NAT
Traversal to force ePBX40 to ignore the contact information
from the IP Trunk and use the address from which the packets
had been received.
Port Port is used to define SIP signal port if you want to listen from
a different SIP signal port other than 5060. Welltech strongly
suggest not to use 5060 port because it is easy to be hacked to
make expensive international call. We suggest you to use port