Eagle Electronics IntelliMap 320 User Manual
Page 21
15
Front view (left) and side view (right) showing dimensions of the
IntelliMap 320 when mounted on gimbal bracket.
After drilling the hole, pass the antenna connector
up through the hole
from under the dash. Pass the power cable's bare-wire end
down
though the hole from the top.
If you wish, you can fill in the hole around the cables with a good ma-
rine caulking compound. (Some marine dealers stock cable hole covers
to conceal the opening.) No matter what type of installation you prefer,
be sure to leave enough slack in the cables to allow tilting or swiveling
the IntelliMap 320. If you choose to fill in the hole, be sure to position
the cables against the rear edge of the hole as you apply the fill mate-
rial.
Before positioning the bracket, be sure to hold the cables against the
rear edge of the hole. Then, slide the bracket over the hole and butt the
rear of the bracket base firmly against the cables, thus pinning them in
place against the side of the hole. Finally, fasten the bracket to the
dash. Attach the unit to the gimbal bracket using the supplied gimbal
knobs and washers.
In-Dash Installation
You can mount the IntelliMap 320 in the dash with an optional FM-5
In-Dash Adapter Kit. The kit includes mounting hardware, a template
for cutting the hole and an instruction sheet, part 988-0147-43.
Millimeter
[Inch]
23.4
[0.92]
72.9
[2.87]
137.9
[5.43]
56.9
[2.24]
157.9
[6.22]
173.9
[6.85]