Eagle Electronics IntelliMap 320 - Manual (Page 20)

14
Bracket Installation
Mount the IntelliMap 320 in any convenient location, provided there is
clearance behind the unit when it's tilted for the best viewing angle. You
should also make sure there is enough room behind the IntelliMap 320 to
attach the power and GPS antenna/receiver module cables. (A drawing on
the next page shows the dimensions of a gimbal-mounted IntelliMap 320.)
Holes in the bracket's base allow wood screw or through-bolt mounting.
You may need to place a piece of plywood on the back side of thin fiber-
glass panels to reinforce the panel and secure the mounting hardware.
Install the gimbal bracket. Orient the bracket so the arms slope toward
the front of your unit.
Drill a 1-inch (25.4 mm) hole in the dash for the power and antenna
cables. The best location for this hole is immediately under the gimbal
bracket location. This way, the bracket can be installed so that it covers
the hole, holds the cables in position and results in a neat installation.
Some customers, however, prefer to mount the bracket to the side of the
cable hole — it's a matter of personal preference.
Front