Eagle Electronics IntelliMap 320 - Manual (Page 19)

13
For example, if you have to extend the power cable to the battery or
power buss, attach one end of the fuse holder directly to the battery or
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.
Power connections for the IntelliMap 320 GPS unit.
CAUTION:
Do not use this product without a 3-amp fuse wired into the power
cable! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
An optional 8-foot, CA-4 external power cable with a cigarette lighter
adapter is available from Eagle.
Mounting the Unit: Bracket, In-Dash or Portable
You can install the IntelliMap 320 on the top of a dash with the sup-
plied gimbal bracket. It can also be installed in the dash or mounted on
a portable power supply.
If you use the supplied bracket, you may be interested in the optional R-A-
M

bracket mounting system. This converts the unit's gimbal bracket to a
swivel mount, which can be used on the dash or overhead mounting posi-
tions. Installation instructions are supplied with the R-A-M mounting kits.
Optional R-A-M mounting system.
12 volt
battery
Red wire with
3 amp fuse
To unit
Black wire
Optional power off switch for
saltwater installations