Verilink IMUX (880-503137-001) Product Manual - Manual (Page 27)

Verilink IMUX User Manual 3-1
Chapter
3
Configuration Menus
The IMUX menus are accessed from the System Controller Module
(SCM). For detailed information about the SCM and its control
options, see the SCM User Manual.
Craft Interface To access the IMUX Main Menu, use an ASCII terminal emulator
connected to the SCM Craft (L
OCAL ) port. This section uses the IMUX
module to show the Craft port ASCII screens. Set terminal
emulation to match the following values:
• 19,200 data rate
• 8 data bits
• 1 stop bit
• No parity
• No flow control
1. At the pSH+> > > > prompt type “craft” and press E
NTER .
2. At the password prompt type “systest”, and press E
NTER (SCM
System Superuser default password).
The SCM Main Menu displays.
Shelf/Slot
Selection
To select a shelf and slot to manage, type “S” and press E NTER . Type
the slot number of the desired module (IMUX is denoted with an I),
then press E
NTER . The screen updates to display the selected shelf
and slot in [ ] brackets. Figure 3-1 shows the IMUX Main Menu.