Triplett Fox 2 & Hound 3 – PN: 3399 - Manual (Page 29)

29
next to the FOX 2. Test the setup by setting the FOX 2 to
TRACER TONE, and turning on the cordless handset. The
tracer tone should be heard clearly in the handset. Momen-
tarily short the clip leads of the FOX 2 together. The cadence
of the tracer tone should change. Connect the clip leads to
the wires of interest. Proceed to other end of the cable, tak-
ing the cordless phone with you, and locate the target wires
by momentarily shorting the suspect wires together until the
cadence of the tracer tone heard on the handset changes.
If testing sensors on a security system, the user can con-
nect the FOX 2 to the wire pair of interest, proceed to the
location of the sensor with the cordless handset, actuate the
sensor, and listen for the cadence change on the handset.
For example, a door or window can be opened and closed
to actuate its magnetic sensor, which is verified by the ca-
dence change.
TRACER TONE
VISUAL CONT.
TALK
OFF / POLARITY
AUDIBLE CONT.
WARBLE PULSE
CORDLESS INTERFACE
UNLOCK BATTERY TEST
AC / RING
REV NORM
Figure 4
Connecting FOX 2 to Cordless Telephone
Cordless Interface