Triplett 2000 User Manual
Page 17
Page 17
3.6.3
D-cell Battery Test
Place the Test Set Range Switch in the Rx1 position. Short the test
leads together (they must be in the VOM and COM jacks). Depress
the Push For Ohms Switch and, using the Ohms Adjust Control,
attempt to set the Pointer to full scale deflection. If this is possible,
then the D-cell battery is good. If the Pointer cannot be set to full
scale, then the D-cell battery must be replaced. Replace this bat-
tery if necessary, then repeat this test. Only after successfully pass-
ing all of the preceding tests is the Test Set ready for use.