Triplett 2000 User Manual
Page 14
Page 14
3.4
Visual Inspection of the Test Set
Before use, inspect the Test Set for any conditions which would
make it unsafe. Check for missing or loose parts ( knobs, screws, or
insulators ). Check also for damage, such as cracks, chips and burn
marks. Make certain that the Test Set is free from oils, grease, dirt
and excessive moisture. IF ANY OF THESE CONDITIONS ARE
FOUND, DO NOT USE THE TEST SET.
3.5
Visual inspection of the Test Leads
Before use, inspect the test leads for worn or cut insulation. Check
also for deterioration of the insulation. Make certain that no wire is
exposed and that the jack insulators and alligator boots are not
cracked, broken, torn, or otherwise damaged. Check also for loose
or missing parts. IF THE TEST LEADS ARE IN ANY WAY DAM-
AGED OR DEGRADED, DO NOT USE THEM. THEY MUST BE
REPLACED. DO NOT USE TEST LEADS THAT HAVE BEEN AL-
TERED OR ARE NOT A FACTORY APPROVED REPLACEMENT.